Amp Wiring

[Jdubb5005]

How would you guys go about running a power wire from the battery to the trunk on a 96 beretta? I can't seem to find a hole in the firewall to run it through and I really don't want to drill a hole. Is there a spot that I may be overlooking? Any help appreciated thanks.

[NotAMonte86]

If it's an automatic, then there should be a grommet on the driver's side of the firewall where the clutch pedal normally goes. Or there's usually a bundle of wires going through the firewall, you can send it in with them.
Or you could always run the power wire out through the hood, in through the passenger side window, and to your amp! Yes, I have seen it before. :doh5:
Or, just drill a hole.

[Sniper]

DO NOT run it through the door jam....find the clutch grommet if it's an auto, or look close to the master cylinder....usually the grommet there is big enough to get something through....but really, drilling is you're best bet..get a step up bit, check both sides, and go at it....couple squirts of primer, slap in a plastic grommet, and you're done in five minutes....

[Jdubb5005]

thanks man... I dont think im going to go with option two but 1 should work for me.

[Dr. Disque]

I have mine running through my door jam, been there for 3 years, never had a problem, it's not a problem if you check it every day for the first few weeks making sure its not binding on anything.

My car doesn't have a hole for the clutch since they didn't make manual ones.