recommended setup

[JRSC INTEGRA]

I just intalled a pair of Skunk2 cam gears, and was wondering if anyone recommends a setup for a supercharged engine(i.e. intake and exhaust degrees)?

Also anyone else with a JRSC COULD YOU PLEASE HELP WITH THIS ONE.

[SE-Rage]

The best way to do it is to take it to a dyno so you can optimize the power gains.

In general, you want overlapping of the valves, the question is how much overlap. A smaller amount of overlap tends to give more top end power while mid range suffers. A large amount of overlap tends to give more low/mid range power but top end suffers a bit. This is just in general. Again, the best way to do it is to take it to a dyno so you can see how much is being gained and how much is being lost. Whatever you gain somwhere on the powerband, you'll usually lose on the other end, so it also depends on what kind of driving you're going to do and where you want most of your power to go.